QueueMetrics > Outbound and QueueMetrics

Outbound dialing using queue dial to multiple/fail over trunks

(1/2) > >>

jmccall:
I've recently implemented the QM outbound dialing on my FreePBX 2.8/Asterisk 1.4 box and had a problem when my providers primary server was not accepting calls, I have a fail over server setup for them in the trunks and normal outbound routes can use the fail over.

My question is how do I setup the [queuedial] to fail over if the primary is down.

Thank you
Jason

QueueMetrics:
It is seen as a normal trunk in TrixBox, so you should use it the way you would with any other trunk.

jmccall:
Yeah I do have the outbound route going to the queue dial. I'm talking about in the dial plan the manual that I've seen so far only gives info on one trunk...



--- Quote ---Will let you call number 012345678 as Zap/g0/012345678 that is, will dial it on the fist available channel in your Zaptel card.
You may otherwise have a format like SIP/myprovider/012345678 that will dial numer 012345678 through a SIP trunk called "myprovider".
You should also add the following piece of code to your extensions_queuemetrics.conf file (make sure it’s not already present):
--- End quote ---

on http://queuemetrics.com/manuals/QM_Trixbox-chunked/ar01s03.html what I'd like to setup is if 'myprovider' fails that it will try 'myproviderbackup'.

Thank you
Jason

QueueMetrics:
You should set it up at a higher level - when you define the trunk, the trunk will fail if the call does not go through, so you should try another one. It is correct that the single call on the single trunk just fails.
 

jmccall:
Sorry I guess I'm not the best @ advanced * or QM configuration, hence the freebpx install  :). Can you point me in the right direction?

Thank you
Jason

Navigation

[0] Message Index

[#] Next page